Announcement

Collapse
No announcement yet.

ZL1 running 11's stock......Nice

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • ZL1 running 11's stock......Nice

    Stock 2012 Camaro ZL1 Runs Quarter Mile in 11.93 Seconds - YouTube

    From C5......
    DETROIT – The 2012 Chevrolet Camaro ZL1 is officially in the "11-second" club, as engineers recently turned an 11.93-second/116-mph quarter-mile elapsed time run in a showroom-stock Camaro ZL1 automatic. A Camaro ZL1 manual ran an 11.96-second ET at 117 mph.

    Only a few other production vehicles can run the quarter-mile as quickly as the ZL1. Fewer yet can also run 0-60 in 4 seconds, reach a top speed of 184 mph and lap the famous Nürburgring in 7:41.27 – all with the street-legal, factory-issued components and no time-consuming equipment adjustments at the racetrack.

    "The ZL1 is great at everything and we're very proud of that," said Tony Roma, Camaro ZL1 program engineering manager. "You can take it to the drag strip and run 11-second quarter-miles all day long. You can also take it to a road course, where it's balanced, handles well, and does exactly what you want – including lapping Virginia International Raceway's Grand Course in under three minutes – and yet the ZL1 is sophisticated enough to use as a daily driver. It's a supercar you can drive every day."

    For perspective, the Camaro ZL1 is so quick that some drivers who experiment with "drag radial" tires or full racing slicks may find themselves going too quick for most NHRA-sanctioned racetracks, where a five-point roll bar is required for vehicles running 11.49 or quicker. The 11.93-second ET in a stock ZL1 tested by the engineers wore the factory-issued Goodyear Eagle F1 Supercar G:2 tires developed specifically for it, putting the car only a scant 0.44-second away from that additional racing safety requirement.

    Tuned for the drag strip

    The original, special-order 1969 Camaro ZL1s are still revered for their legendary performance on the drag strip and Chevrolet was keenly aware that customers for the new, 21st century edition would undoubtedly test its straight-line mettle in quarter-mile increments.

    The Camaro team re-engineered 30 percent of a Camaro 2SS to make the ZL1, including special modifications just for the drag strip.

    "We know many of customers will take their ZL1 to the drag strip," said Gordon Rojewski, driveline development engineer – and who is also an experienced drag racer and owner of a turbocharged, 920-horsepower street car. "Some may just go once, to experience the full potential of the 580-horsepower LSA engine. Others may be more serious, going every other weekend with a set of slicks in the trunk. As such, we set out to make sure the ZL1 would perform for them – on the first pass and on the 100th."

    For example, to withstand the heavy loads of repeated hard launches, the ZL1 features a stout 9.9-inch rear differential mounted in a robust cast iron center section. It also features a standard differential cooler that can lower the temperature by 100 degrees F for improved performance and longevity.

    The ZL1 also features asymmetrical half-shafts: a 60mm hollow shaft on the right and a 33mm solid shaft on the left. The different torsional stiffness rates of the shafts work in conjunction with the limited-slip differential to minimize the chance of wheel hop at launch. Engineers modified the rear suspension, as well, to accommodate an 18-inch wheel, for owners who want to fit a set of drag-radials with taller sidewalls to improve their ETs.

    Even the ZL1's exclusive Performance Traction Management (PTM) was tuned for the drag-strip. It integrates third-generation Magnetic Ride Control, launch control, traction control, electronic stability control and electric power steering response to enhance performance. Launch control (manual transmission only) automatically modulates engine torque for the best-possible acceleration without excessive wheel spin. When the driver pushes the throttle to the floor, the system holds a predetermined engine speed until the driver releases the clutch. Then, the system modulates engine torque 1,000 times per second to maximize the available traction.

    Mode 5 of launch control is uniquely calibrated for drag strips that use VHT or similar traction-enhancing compounds on the starting line. In addition to validating the system for the stock tires, engineers also tested it with 18- and 20-inch racing-type drag radial tires in anticipation of the specialty tires many drivers will use at the track. Drag radials are very soft and provide nearly the traction of a full racing slick, allowing the car to launch at a higher rpm without wheel spin, which can translate into an even quicker ET.

    Proven with 1,000 hard launch tests

    To test the chassis and suspension components to ensure they were up to repeated hard-start launches typical at the drag strip, engineers subjected the ZL1 to the grueling "Woodward Avenue Schedule" at the GM Milford Proving Ground.

    Named for the famous cruising route that cuts north through Detroit's suburbs and has been the venue for untold thousands of unofficial launch capability demonstrations since the 1960s, each test cycle is a hard-launch, standing-start drag race up to 100 mph. The ZL1 was subjected to 1,000 test cycles before its driveline was stamped "approved".

    "The Woodward Avenue Schedule was a really brutal test, but it told us the Camaro ZL1 would live up to the way we knew our customers would drive it on the track," said Rojewski.

    The Camaro ZL1 is on sale now with a suggested retail price of $54,995 – including a $900 destination charge. The 6L90 six-speed automatic transmission includes TapShift control and is a $1,185 option. The Camaro ZL1 convertible goes on sale this summer.
    2018 ZL1 A10 Convertible, Kooks Longtube Headers (to be installed 8Jan) Full Kooks exhaust from Kooks R&D in Mooresville, NC, ZL1 painted GFX, My ShowStopper Custom Engine Cover Kit and painted CAI. For Sale! Color Shift Lights coming soon[/SIZE][/B]


  • #2
    I was the one in the C5 thread who checked on whether the 11.9 passes were on stock tires or DR's. I checked with my friend Jeff who is the track manager at Milan.

    I'm impressed to see the cars crack 11's, and hope to see those ET's drop over the next year as they are likely to do as more folks buy them.
    2010 Camaro SS/RS L99
    13.15@106 1.95 stock
    11.84@113 1.59 bolt-ons stock internal
    10.90@125 1.47 GPI VVT Cam + Bo White Ported Heads

    Comment


    • #3
      In the video there are 2 11.9 timeslips and both of the 60's are in the high 1.6's. I don't think a stock Goodyear can hold that much power to get a 60' that good. I find it hard to believe that a stock stall would allow that too.

      Comment


      • #4
        ...if I only had $60K...
        sigpic
        2010 2SS/RS #55 NicKey Stage 2S Super-Camaro, custom paint by Pete (Mr. Showstopper)
        Build thread: http://www.chicago5thgen.com/5th-gen...ld-thread.html

        Comment


        • #5
          Originally posted by DarkSS View Post
          In the video there are 2 11.9 timeslips and both of the 60's are in the high 1.6's. I don't think a stock Goodyear can hold that much power to get a 60' that good. I find it hard to believe that a stock stall would allow that too.
          There's alot of engineering going on there, including the PCM factoring in the characteristics of the stock GY tires...

          Comment


          • #6
            I can run a 1.6 60ft for 20k less, what's the big deal?

            Comment


            • #7
              For what you pay, you should expect that. However, it is really good to see that there is good competition out there against Ford and their Shelby.
              sigpic
              2011 1LT/RS
              Transformers Special Edition
              Trifecta Performance Custom Tune
              SLP Blackwing Cold-Air Induction Package
              Gibson Muscle Car Axle Back Exhaust System

              Comment


              • #8
                I also highly doubt the 1.6 or 1.7 short times on stock tires.
                High 1.8 at best - the ZL1s OEM tires are definitely NOT made for drag racing.

                Comment


                • #9
                  Originally posted by Octane View Post
                  I also highly doubt the 1.6 or 1.7 short times on stock tires.
                  High 1.8 at best - the ZL1s OEM tires are definitely NOT made for drag racing.
                  This guy definitely converted to the dark side. Doubt have you? Doubt leads to mistrust, mistrust leads to anger, anger leads to the dark side of the chevy force. So what year vette are you getting?

                  Comment


                  • #10
                    That's it?


                    2003 EB Z06
                    1984 Mustang GT-350 (20th Anniversary Edition) - 1 of 670 made.
                    2012 Camaro 45th Anniversary 2SS/RS 6-speed Coupe (sold)
                    2011 Camaro 2SS/RS Vert 6MT (Lemon-Sold)
                    2003 Sonic Blue Cobra 458rwhp/458rwtq (Sold)
                    1996 Mystic Cobra 455rwhp/400rwtq (sold)
                    1999 BGC T/A 377rwhp/360rwtq (sold)
                    2004 Silver Cobra 600rwhp/540rwtq (sold)

                    Comment


                    • #11
                      I'll ask my guy the next time he's online, but he runs the track at Milan and I've known him for a good 6 years, straight shooter. 1.6 on stock tires is hard to believe, but maybe the track was super prepped.
                      2010 Camaro SS/RS L99
                      13.15@106 1.95 stock
                      11.84@113 1.59 bolt-ons stock internal
                      10.90@125 1.47 GPI VVT Cam + Bo White Ported Heads

                      Comment


                      • #12
                        I'm going with super prepped.. No way in hell that an OEM tire ran 1.6-1.7 60's like that on a 4100lbs, IRS Camaro.. Vette's don't even do that with more tire and less weight. I believe they even said the best times were with PTM off, so it's not like the computer helped.. I've already been flamed over on the fanatic site.. so, I've tried to stay out of it.. I don't care either way, I just don't like feeling like I'm being fed garbage data for the sake of sales and image. I think the vast majority of us would have believed an 11.9 w/ a 1.9-2.xx 60'.. This isn't just an SS with a blower on it.. It does have extra mass to deal with off the line... That doesn't just go away, not matter how much technology is in it. I mean, GTRs launch like crazy, but they're DCT and AWD... Not exactly the same playing field as A6/M6 and RWD only... Not knocking the car, I think they did an over all good job with it.. There are things about it that I don't like, but I'm that way with even high end exotics.. There's just something fishy about the whole thing and way too many people are skeptical of it for it to be just my own paranoia.

                        Comment


                        • #13
                          Where is the link to the 1.6 info? I talked to my guy, and he thinks the 11.9 stock passes were 1.9 60 ft times. So maybe the info that was put out there is a bit jumbled.
                          2010 Camaro SS/RS L99
                          13.15@106 1.95 stock
                          11.84@113 1.59 bolt-ons stock internal
                          10.90@125 1.47 GPI VVT Cam + Bo White Ported Heads

                          Comment


                          • #14
                            Originally posted by Pro Stock John View Post
                            Where is the link to the 1.6 info? I talked to my guy, and he thinks the 11.9 stock passes were 1.9 60 ft times. So maybe the info that was put out there is a bit jumbled.
                            It's in the video they posted. If you pause where the two timeslips are shown, you can see the ET/Trap/60 easily on one and most of the data on the other. The ET in the time slip was right at what they claim top time was, but it showed a 1.69/1.7 60' in each... that added to the fire.

                            So.. There's the oddity in the timeslips with 1.6 60's and an 11.9 (maybe they sand bagged -- but, if so, why post that time?)
                            No full outright track runs showing OEM tire and ET/Trap on the boards.
                            No comment on how many gallons of VHT was on the track
                            The claims of 1.69s on GY PS2s (still hard to stomach with this car)
                            etc....
                            Attached Files
                            Last edited by Guest; 05-09-2012, 11:58 AM.

                            Comment


                            • #15
                              The ZL1 OEM tires are built for road racing, so they're gonna have a stiffer sidewall.
                              I have a hard time believing that a stiff-sidewall tire put down a 1.6 short time.

                              Comment

                              Working...
                              X