Solo mach XL impressions

[steveo9043]

So I got the exhaust installed yesterday morning.

Impressions
-removal and install were easy. (2.25 hours on the ground)
-Quality is very good
-quieter then expected
-good looking tips

Only issue I am having is a small rattle over bumps. I think this is coming from the pipes hitting the cross member. We were a little concerned with that when we saw how they sat when we got them in there.

any suggestions on how to fix that?

[Toasty]

So I got the exhaust installed yesterday morning.

Impressions
-removal and install were easy. (2.25 hours on the ground)
-Quality is very good
-quieter then expected
-good looking tips

Only issue I am having is a small rattle over bumps. I think this is coming from the pipes hitting the cross member. We were a little concerned with that when we saw how they sat when we got them in there.

any suggestions on how to fix that?

Hitting crossmember or tunnel brace?

[steveo9043]

tunnel brace, the DIY writeup I was reading when doing the install kept saying cross member. So i keep saying it now lol

[Toasty]

tunnel brace, the DIY writeup I was reading when doing the install kept saying cross member. So i keep saying it now lol

Take tunnel brace off, add a washer or two between brace and frame on each bolt

[Bubbles]

Take tunnel brace off, add a washer or two between brace and frame on each bolt

agreed on that one... my tech added 2 to each side on both and other people's camaros who have headers

[steveo9043]

Thats what i was thinking. Just wanted to get some others opinions.

[Bubbles]

Peanut (my tech) says 2 washer for each bolt and you will be golden :P

[Butters]

Add a Tru-x pipe, that should add a little volume

[steveo9043]

I'm thinking about an x pipe or doing high flow cats.... but if I do high flows I might as well do headers.

If i do headers got to get it tuned.

If i get it tuned might as well go further since my warranty is gone...

lol

[Butters]

Haha, good point!