Need help from a shop for pushrods

[SYCK SS]

Looking for any vendors to help a brother out.

I have had the worst headache with this engine build.

Anyways, I'm looking to see if there is a shop that can squeeze me in just to triple check that I am running the proper pushrod length. I have had absolutely no luck getting communication with AES. So I'm looking for a helping hand.

PM me or let me know what it would run me. Thanks in advance.

sent from my Note 3 using Tapatalk... that eoukd explain any errora

[SYCK SS]

never mind... NicKey it is!

Thanks again Stefano!

sent from my Note 3 using Tapatalk... that eoukd explain any errora

[Pro Stock John]

If they decked and blocked the heads, would you need near stock length of maybe 25 thousands shorter?

[SYCK SS]

If they decked and blocked the heads, would you need near stock length of maybe 25 thousands shorter?

I had a buddy come by today and he checked them for me. He said they seemed good to him too.

The thing is I plan on getting a cam in the next month or so. So i would hate to have to order 2 sets of pushrods if the stock ones are fine.

But at the same time I want to make sure it's safe. so I was actually thinking of just getting 25 shorter. I don't think it would hurt and should compensate for any difference in height.

sent from my Note 3 using Tapatalk... that eoukd explain any errora

[NicKey]

Most cams, such as Comp cams cores are not the same size as your stock Camaro cores..........so generally you end up needing a longer pushrod than Stock when you change your cam.