boost a pump

[SYCK SS]

i was just curious is anyone has one installed on their car. i am in the process ok tweaking the setup of my car and noticed that at about 6 lbs of boost my fuel pressure drops to about 48 lbs.

My AFR is fine but i just dont like that the pressure is dropping so low. i was wondering if anyone took this route to fix this.

[1stGM]

Yes, installed the Kenne Bell BAP on my Procharged car. Car made 591 RWHP @ 5psi... There is a specific way to wire these, though....

[SYCK SS]

yeah i have been reading up on it alot and i can see how complicated it is. how did you know where to set the voltage at? was it a test and tune basis?

[1stGM]

Actually, the wiring is very simple, but it needs to be wired AFTER( I think, I would have to double check) the fuel pump control module... There is only 4 wires or so involved....

I set the voltage at the max setting as per Speed inc, who did the tune... The BAP references boost, so it will only increase voltage to the pump under boosted situations...

[SYCK SS]

awesome thank you very much! exactly what i was looking for.